Well I modded a Peavey Reactor tele-clone some years ago with a 5-way super switch and a hot rails thing in the bridge position. The neck on that is not so great so it's spent a lot of time in the closet. One of the positions was everything in series although I can't attest to how wonderful that is.
As far as your JD pickups, I like the descriptions of the settings; trying to figure out what they mean.
1 is just plain old neck pickup.
2 slaps a fixed "woman-tone" cap on it
3 "customized parallel wiring" - hmmmm not sure what to make of that
4 both pickups with a cap and resistor? Not clear but intriguing
5 - regular old bridge, I mean, specially enhanced for your dining pleasure?
I was going to suggest some of my favorite old Yamaha AES-800 wirings, which I've written about at some length over in the "Pickups" area of the Forum.
1) Series humbucker with a cap to ground - pulls out mids depending on cap value and pickup inductance
2) Two single coils wired in parallel with the other coil as a shunt load to ground through a cap.
Looked a Bill Lawrence Q-filter - they claim it is an LCR, although they maddeningly only list the inductance? Gah!
|